Reset of Maint. required message
 

Hello, I have a 05 CLK 500 can someone tell me how to reset the message
(Maint for Sched A exceed by XXX days.) I had this work done at a local
garage. the tech did not reset the message.. anyone know how I can reset this message.

Thanks for the help!!!

Here's the steps - they are also in your owners manual

1) Turn key to position 1
2) With the display in the "default" normal driving position, (this should be speed or temperature) press the reset button three times.
3) The display will now read the battery voltage
4) Press down arrow once to get to service menu
5) Press "-" (minus) three times until you highlight "confirmation"
6) Page Down (key next to arrow down) to advance to the next menu
7) You should see Confirm Full, Cancel Full, Cancel Items.
8) Turn ignition key to position 2 (I think you could do this anytime after step 4 above)
9) Press Page Down while Confirm Full Service is highlighted
10) You should get a message confirming success
11) Repeat Page Up (key next to up arrow) until you reach the standard display
12) Start the engine
13) Page up to the screen that normally says Service "X" in "NNNN" miles. It should read "Reading Data Please Wait".
14) After 30 seconds or so it will read "Service "X" in 13000 miles.

1) Turn key to position 1
2) With the display in the "default" normal driving position, (this should be speed or temperature) press the reset button three times.
3) The display will now read the battery voltage
4) Press down arrow once to get to service menu

At this point I get the VIN infor.. not the service menu.. Am I doing something wrong?

Confused..
 

:(

The procedure for mine is in the OM.......did you check there?

Yes I looked at the OM but Either I looking at the wrong information or I don;t understand what the OM instruction

What instruction did you find in the OM?