|
|
|
#16
|
|||
|
|||
Last observation guys. The compressor cuts out...doesn't reengage (that doesn't look right) until I turn the controller on the dash off..then back on . and sometimes that won't work imediately, I have to wait 30 or so seconds after I turn it off to turn it back on effectively.
|
#17
|
|||
|
|||
Your pressures look good. The low side might be a little low if its still R12.
The pressures are probably not your problem. The fact that it takes recycling the key may not mean anything other than to say that is probably a controlller issue. I would say that that is the way the comressor controller works though. If it sees a engine problem, probably only voltage or rpm on your car, it shuts down untill the key is cycled.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
#18
|
|||
|
|||
been there, done that. there's a host of possibilities associated
to this kind of problem. from belt slippage all the way to the pushbutton control unit. my problem was caused by a loose wire connection located atop the compressor. |
#19
|
|||
|
|||
Did you check the evap temperature sensor? A bad sensor would cause the same problem that you are describing.
Vinamg |
#20
|
|||
|
|||
Yes and thanks for the reply. The tech just replaced the ev. sensor and there was no benefit.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air Con Conversion in UK (190e) | webcentre | Tech Help | 0 | 08-06-2004 11:20 AM |
Air filter housing for 1991 420SEL | BENZ-LGB | Tech Help | 1 | 05-11-2001 05:18 PM |
Second Ram Air '87 300E Thanx Larry Bible | dlswnfrd | Tech Help | 22 | 02-01-2001 06:29 AM |
Cleaning out your Air Box | Chris Ecklund | Tech Help | 2 | 06-28-1999 07:49 PM |
Air Con installation | mehdi | Tech Help | 4 | 04-09-1999 08:47 AM |