Winshield Washer W123 - Tricks anyone?
I need to replace the windshield washer jets on by 1977 300D, 123.130. MB Manual has a special tool for removal. I was going to buy a short length of steel pipette, to unpop the two clips loose.
Anyone tried this or a similar approach. |
I used two long screwdrivers and pushed the clips in and it popped right out.
|
Thanks
I tried that approach, maybe I'm not coordinated enough to get it done.
Since you have set the standard, I'll give it another shot this PM. Thx again, JCD |
I used a nut driver with a hollow shaft. I don't remember the size, probably about 10 or 12 mm or so.
|
All times are GMT -4. The time now is 07:22 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website