Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 12-21-2001, 09:53 AM
djoyce93
Guest
 
Posts: n/a
making sure it will start at 40 below

I recently purchased a 1983 300 D TD with 320,000 KM. (about 200,000 miles) on it and I plan to use it year round. In Ottawa where I live the temp. can range from 90 F. in the summer to -40 F. in the winter. Please give me as much advice as possible to increase my chances of starting every time in the winter. Thanks, Dave Joyce

Reply With Quote
  #2  
Old 12-21-2001, 10:13 AM
Registered Diesel Burner
 
Join Date: Aug 2001
Location: Northern Virginia
Posts: 2,911
Don't turn it off.



Ken300D
Reply With Quote
  #3  
Old 12-21-2001, 10:15 AM
Registered User
 
Join Date: May 2000
Location: Boise, Idaho
Posts: 80
Hi Dave, I believe that many folks on this forum will recommend, as I do, that you use a synthetic oil with a small winter number, such as 0 or 5W and a block heater. There are many threads which more than adequately cover these areas. Use the search engine! In addition, a properly "tuned" diesel will run great in cold or hot climates. Roger
__________________
Roger
1983 300CD 246k sold
1998 C230 52k
1980 450SL 75k needs AC
1999 Subaru Outback Ltd 43k
Reply With Quote
  #4  
Old 12-21-2001, 02:17 PM
djoyce93
Guest
 
Posts: n/a
Wink

Thanks Ken, maybe I could just move to Florida instead!
Reply With Quote
  #5  
Old 12-21-2001, 08:27 PM
Registered User
 
Join Date: Jun 2001
Location: Omaha, NE
Posts: 962
Yep, synthetic oil (e.g. Mobil 1) is your best bet. It really lets the engine spin faster when cranking which in turn lets it develop more heat in the cylinders.

The other major tip I've heard is to use the glow plugs liberally. In really cold weather, some go through 3 cycles (i.e., turning the ignition to the "2" position and keeping it there till the glow plug light goes off. Also, the glow plugs keep heating for up to a minute or so after the glow plug light goes out -- you can listen to the relay and keep the key in "2" until the relay clicks.

Once glowed adequately, crank it and keep cranking until the engine runs smoothly. Don't stop cranking once the engine "hits" the first time, wait until it's really running (but don't exceed the cranking time limit in your owner's manual).

Oh, one other thing -- make sure fuel filters are clean. Apparently diesel fuel is more likely to gel in the filters if they're dirty.
__________________
Steve
'93 400E
Reply With Quote
  #6  
Old 12-21-2001, 11:00 PM
blackmercedes's Avatar
Just a guy
 
Join Date: Dec 2000
Location: St. Albert, Alberta, Canada
Posts: 3,492
Make sure you drive the car and don't have fall-formulated-fuel in your tank.

Use a block heater at -10C or lower.

Use Mobil 1 0-30 or 5-30.

Make sure your battery is in top condition. Diesels need good batteries. You're running the glow plugs and the starter.

As mentioned, let the glow plugs go past the light-out until the relay clicks. This REALLY works. My wife forgot to plug her diesel in the other night, and it was -26. She let the relay click, and VROOM, off she went.

Don't do short trips with starting and stopping the engine. Not only is it tough on your engine, but it's hard on your battery.

And yes, clean fuel filters are required.
__________________
John Shellenberg
1998 C230 "Black Betty" 240K

http://img31.exs.cx/img31/4050/tophat6.gif
Reply With Quote
  #7  
Old 12-21-2001, 11:51 PM
Registered User
 
Join Date: Jun 1999
Location: Los Angeles, Calif, USA
Posts: 521
If the engine has low compression, you will have hard time to start it at low temperature. One of the causes of low compression is the valve adjustment too tight. Adjustment the valves now and then perform a compression test.

Read the owner's manual. It has a sestion of starting the car at low temperature.

David
Reply With Quote
  #8  
Old 12-22-2001, 12:59 AM
Registered User
 
Join Date: Nov 2000
Location: Vernon, CT
Posts: 1,848
Use some diesel additive to prevent gelling. I don't know if Power Service products are available in your area, but they have an additive that will literally ungell, gelled fuel. If you'regoing to be doing errands let the car idle.

__________________
1999 MB SL500 (110,000 mi)
2004 Volvo V70 2.5T (220,000 mi)
2014 Tesla Model S 85 (136,000 mi)
MBCA member
Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
16V - hard start Prime16 Tech Help 5 01-03-2005 12:20 PM
Please help me start a non-starting 240D. ericnguyen Diesel Discussion 4 05-15-2003 09:58 AM
What may be wrong if a 1981 Mercedes 240D can only start when doing a push start? ericnguyen Diesel Discussion 5 03-26-2003 10:40 AM
260E has sparks but will not start saumil Tech Help 3 08-17-2001 02:29 PM
1991 420SEL - beginning of a cold start problem DieselGuy Tech Help 1 07-30-2001 03:56 AM



All times are GMT -4. The time now is 07:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page