PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   W126 Memory seats (http://www.peachparts.com/shopforum/tech-help/285013-w126-memory-seats.html)

LandYaghtLover 10-25-2010 02:03 AM

Quote:

Originally Posted by Billybob (Post 2571443)
The antenna gets 12v power from the red wires, the blue wire is an antenna UP/DOWN signal wire from the head unit through the dash switch and back to the antenna. The blue wire tells the antenna circuitry to rise/retract/ partially or fully. The radio frequency signal is a larger coaxial cable which attaches directly to the connector which exits the antena staulk at an angle.

Ok. So I am guessing there was, at one time, a connector which they, for whatever reason, removed and spiced some stuff together. Hence the lack of a blue wire on the antenna, it was probably the white one on the antenna that would have coupled with the blue.

Good to know actually since I have no radio at all right now due to the hack job. Thanks much!

Billybob 10-25-2010 02:19 AM

Quote:

Originally Posted by LandYaghtLover (Post 2571449)
Ok. So I am guessing there was, at one time, a connector which they, for whatever reason, removed and spiced some stuff together. Hence the lack of a blue wire on the antenna, it was probably the white one on the antenna that would have coupled with the blue.

Good to know actually since I have no radio at all right now due to the hack job. Thanks much!

Usually the original loom is chopped when an aftermarket replacement antenna is installed. In the factory install there is a 2X2 four pole female connector at the wire end which plugs onto a connector on the antenna.


All times are GMT -4. The time now is 12:09 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website