1987 300E
 

Due to divorce and a move i had to sell my 1972 220d.I just picked up my next project - a 1987 300E. I'll be asking alot of questions as this model is new to me. The car runs nice and doesnt shift badly. Heres a list of what doesnt work.
2 power windows
sunroof
cruise contol
front headrests
ambient temp guage
e-brake
passenger front power seat doesnt go back - the back works and will go forward just not back

I am looking forward to getting car fully functional again as it drives wonderfully
Thanxx in advance

If all windows do not work, check your fuses. Just order a batch of new fuses and replace all of them. You'll be surprised what they fix! You can try to clean the contact switches in the doors for seat adjustments as they wear out for your headrests and adjustments. Search these forums. Or, order new ones off Ebay. Also could be cables that are rounded out at ends under seat going into drive gears. I replaced both and fixed mine...everything works perfect now. Sunroof...87's are notorious and if fuse doesn't work, just consider it a hard top. E-Brake....mechanical. Should be easy. Cruise control...can't help you. Mine works fine. Best of luck.

Steve

Checking the fuses is most definitely a good place to start. If cleaning the power seat switches does not correct the headrests then you will have to go a bit deeper. The headrests are driven by a gear assembly inside the seatback and they do fail as they get older. If you do a search you should be able to find info on replacing the gear assembly. Does the ambient temperature gauge show a reading or is the screen blacked out? The display is a common failure point and can be replaced relatively easily by removing the instrument cluster where it is screwed on. A working display can often be found for $30-$50 online or at your local salvage yard.

Make sure you get the all fluids and filters changed asap. Especially since you mention the transmission "doesn't shift badly"

After checking the fuses for the windows, establish if it is the wiring or the motor that is dead. Pull the panels off and apply a 12V battery to the terminal attached to the door to see if the motor moves. If it does, wiring is frayed in the door, if not, motor replacement!

start working on it tomorrow - have to replace headlights also (received those today) - gonna do the fluid changes also have to replace valve cover gasket - the headrests, drivers side missing switch.the pass side when you use switch you can feel it move in the seat but it doesnt move the rest its self. The pass windows tha dont work, when you hit the switch the lights dim but they dont move. the temp gauge is black - found one on ebay for 25.the things that surprise me is the dash clock doesnt lose a minute and the rear defroster works great.Also the seat adjustment switches only work if the door is open - i find that perplexing.Thank you guys for the help so far, this at first seemed a daunting task but looks like i'll be able to get this beauty back roadworthy soon.

Headrest - broken gear. Remove seatback and investigate. Screw at bottom, then pull down.

Windows - sounds like you have power, remove door panel. Screws at lock plate at rear, remove black plastic behind door handle to find screw, then remove door handle and then seat switch. Check to see if the regulator is bound up. Door panel lifts UP to remove. Be very careful not to break any of the hooks.

Temp display - Earlier cars had different pin out than later. Check archives for fitting a later one.

Seat adjustment - Seat switch will work only if door is open OR if ignition is turned on. Key off, door closed, no power....


Jim

The temperature display will not work unless you have the same type. Different circuit boards and pin layouts. I see (I have tried) no way to mix/match or make it work. Just the way it is.