Hello everyone,

since a few days my car is getting cold start difficulties

I measured the tension on the connector of the cold start valve and no voltage at all.

The car is the W124 260E from 1988,

Would any body have any suggestion where to look for?

In advance many thanks

__________________
Keep us posted especially if your problem is solved
Present cars:
My car: E-class 420CDI, 2008, W211, V8, 180 000km

Wife's one: C-class 220CDI Sport Coupé, Euro, 2002, W203. 345 000km

Son's one: GLK class 220CDI, 2009, W204

Sold E class 260E, W124, 1988 beloved car sold after 489 000 kilometres of reliable services (engine M103, clutch and 5 speed manual gear box all original).

E-class, W210 320CDI, 2000[/B], 225 000km, Sold

The only time you can check for voltage is while you are operating the starter.

__________________
MERCEDES Benz Master Guild Technician (6 TIMES)
ASE Master Technician
Mercedes Benz Star Technician (2 times)
44 years foreign automotive repair
27 Years M.B. Shop foreman (dealer)
MB technical information Specialist (15 years)
190E 2.3 16V ITS SCCA race car (sold)
1986 190E 2.3 16V 2.5 (sold)
Retired Moderator

Cold start issues are usually not due to the cold start injector unless you live in the snow.

__________________
2016 Monsoon Gray Audi Allroad - 21k
2008 Black Mercedes E350 4Matic Sport - 131k
2014 Jeep Wranger Unlimited Sahara - 62k
2003 Gray Mercedes ML350 - 122k

thank you for replies.

Any suggestion for a systematic search procedure? Wiring schematic.

I have no clue on where to start from. And now it is freezing here in Europe, minus 5 centigrades with snow

Checked the temp sensors seems oK

once started Idle is fine (even at vey low RPS below 500), the point is to where to start to solve the problem (presently I inject manually some fuel in the air filter housing).

thanks

__________________
Keep us posted especially if your problem is solved
Present cars:
My car: E-class 420CDI, 2008, W211, V8, 180 000km

Wife's one: C-class 220CDI Sport Coupé, Euro, 2002, W203. 345 000km

Son's one: GLK class 220CDI, 2009, W204

Sold E class 260E, W124, 1988 beloved car sold after 489 000 kilometres of reliable services (engine M103, clutch and 5 speed manual gear box all original).

E-class, W210 320CDI, 2000[/B], 225 000km, Sold

the cold start injector is activated for a short period during a cold start ,so check its voltage while someone starts the car.
A low idle RPM with a starting problem point to a fault in the OVP : over-voltage regulator , this powers the cold start injector and the idleing speed along with other circuits
a common fault with the OVP is the fuse or solder joints going bad. Best replaced due to its age fatigue.
mak

__________________
mark