Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 07-05-2011, 02:01 AM
PanzerSD's Avatar
Schießenstern
 
Join Date: Jan 2006
Location: Saskatchewan Canada
Posts: 2,351
Question Fuel pump failure modes

When a Fuel pump fails, or gets to a point where it should be replaced, what are some of the symptoms?

The engine in my car runs great from a full tank, till a little bit past a quarter. beyond that, the idle is lumpy, power is slow and anything but smooth.

I'll put it this way, I can haul ass up a hill in 3rd, with a FULL tank, but at 1/4 I'm downshifting just to maintain 50Km/h.

EVERY tank, and I run 91

Is it possible that my fuel pump is getting weak, and with the added pressure against the pump with a full tank, it works well, but it's ability to deliver the correct amount of fuel pressure diminishes as the weight of the fuel in the tank decreases?

__________________
RIP: 80 300SD
RIP: 79 450SEL
2002 E430 4matic (212,000km)
2002 ML500 'sport'

____________________________
FACEBOOK:
PANZER450
Reply With Quote
  #2  
Old 07-05-2011, 04:39 AM
Stretch's Avatar
...like a shield of steel
 
Join Date: Sep 2009
Location: Somewhere in the Netherlands
Posts: 14,461
Could be but I'd check the tank strainer and the other filters first
__________________
1992 W201 190E 1.8 171,000 km - Daily driver
1981 W123 300D ~ 100,000 miles / 160,000 km - project car stripped to the bone
1965 Land Rover Series 2a Station Wagon CIS recovery therapy!
1961 Volvo PV544 Bare metal rat rod-ish thing

I'm here to chat about cars and to help others - I'm not here "to always be right" like an internet warrior



Don't leave that there - I'll take it to bits!
Reply With Quote
  #3  
Old 07-06-2011, 02:51 AM
sptt's Avatar
Registered User
 
Join Date: Sep 2009
Location: Orange County, California
Posts: 691
Throw a new pump or two at it. Not hard to do.

Steve
Reply With Quote
  #4  
Old 07-06-2011, 10:51 AM
Registered User
 
Join Date: May 2004
Location: Natchez MS and Dallas TX
Posts: 355
Try leaving tank cap loose to see if you're building a vacuum in the tank.
__________________
85 300 SD ~ 115K
82 500 SEC Euro ??K
78 450SL 164K
Reply With Quote
  #5  
Old 07-06-2011, 11:59 AM
Registered User
 
Join Date: May 2007
Location: Arizona
Posts: 760
I just replaced both of my pumps after noticing a subtle rattle/racket sound coming from the rear of the car. After sticking the tip of my stethoscope on the plastic fuel pump cover, it was evident that at least one of the pumps was making the noise. After removing the pumps, I noticed one of them rattled like a gourd when I shook it. I presume this was the bad pump.

Regarding your low fuel tank resulting in a reduced pressure to the pumps, I'm not sure how the input pressure affects the output of the pump, but I will say that when I slid the supply hose off the back of my pump I was surprised at the pressure and amount of flow that came out before I could bend the hose and stop it (my hose crimp tool was not big enough to reach across the whole hose). It was like trying to stop the flow from a garden hose. Unfortunately, I did have a full tank of gas at the time.
__________________
1993 400E, 256,000 miles (totaled)
1994 E420, 200,000+ miles
1995 E420, 201,000 miles
Reply With Quote
  #6  
Old 07-06-2011, 11:18 PM
PanzerSD's Avatar
Schießenstern
 
Join Date: Jan 2006
Location: Saskatchewan Canada
Posts: 2,351
Wow! No sooner had I read emrydc8's comment, then driving I smell gas.
I look and the 2" piece of hose between the fuel damper and the pump was POURING fuel, I lost probably a two litres. I was able to catch one... Good thing I had an available shop with lift! new hose fixed in an hour.
if this hose was seeping for a while, could the pump suck in air via the cracks in that hose?

If that hose had completely broken, as I was driving, it easily would have cost me THOUSANDS of dollars. Not to repair, but for all the other things that would happen.
First of all, there would be no stopping 90 litres of Vpower from going directly to the ground ($120), but the cost of the call to the FD to handle the spill ($975 call out fee), a municipal pollution fine of $3500 - $5000. and because it's a 2" piece of hose that would have failed, my insurance would not have covered it.....
__________________
RIP: 80 300SD
RIP: 79 450SEL
2002 E430 4matic (212,000km)
2002 ML500 'sport'

____________________________
FACEBOOK:
PANZER450
Reply With Quote
  #7  
Old 07-07-2011, 12:43 AM
Registered User
 
Join Date: May 2007
Location: Arizona
Posts: 760
Quote:
the cost of the call to the FD to handle the spill ($975 call out fee), a municipal pollution fine of $3500 - $5000
.

If you were a corporation, you'd probably get a tax break from our government for the loss of valuable fuel and you would make CNN for your heroic effort to stop the spill because it could have been much worse. As a lowly worker ant, I wouldn't be calling anyone but a tow truck.

Glad you found the problem.

__________________
1993 400E, 256,000 miles (totaled)
1994 E420, 200,000+ miles
1995 E420, 201,000 miles
Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 09:14 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page