Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 01-28-2002, 08:03 PM
Registered User
 
Join Date: Sep 2001
Location: Austin, Tx
Posts: 713
300E very fast after a cold start....

Hey guys. Here is the deal, whenever I leave the car (92 300E m103) overnight and then start it in the morning, the car seems to go into superfast mode. I tried it out this morning, and floored the cold engine (I know... its not the thing to do... im sorry) and I managed to break lose the rear wheels in a smoky pealout. Now, this is the 300E we are talking about, and ive never dome a pealout before with this car, so I was impressed. Only problem is, after the pealout, my car returned to normal driving mode, which as you all know... is a bit slow. Ive noticed that my car only enters this "mode" in the morning after sitting overnight, it never enters it during the day, even if the car has been left sitting for a while. So here is the question... what is causing this extra performance? Is it the cold start valve? If it is, could anyone expand on what exactly the cold start valve is? I read that its only on 1 cylinder?? Yea... any help would be appreciated, thanks!

Reply With Quote
  #2  
Old 01-28-2002, 09:17 PM
Ali Al-Chalabi's Avatar
Senior Member
 
Join Date: Nov 2000
Location: Knoxville, TN
Posts: 1,837
The cold start valve on my Bimmer is just an extra injector that adds additional fuel to the engine during the cranking of a cold engine. I believe it serves the same function on the Benz.
__________________
Ali Al-Chalabi

2001 CLK55
1999 Dodge Ram 2500 Cummins Diesel
2002 Harley-Davidson Fatboy
Merlin Extralight w/ Campy Record
Reply With Quote
  #3  
Old 01-28-2002, 09:19 PM
Registered User
 
Join Date: Sep 2001
Location: Austin, Tx
Posts: 713
hmmm... so is it possible to get this valve to open on command... ie wire a switch that will activate the valve, so say when an extra boost of speed is required, you just flip the switch... and take off?
Reply With Quote
  #4  
Old 01-28-2002, 09:41 PM
Ali Al-Chalabi's Avatar
Senior Member
 
Join Date: Nov 2000
Location: Knoxville, TN
Posts: 1,837
I don't think that will work. It is only enrichining the mixture during the start. The valve will just make the car run rich if it were rigged to do so. There is no extra air going into the engine, so the extra fuel would just pass through unburned.

From what I can remember, this valve only functions while the starter is engaged and then shuts off.
__________________
Ali Al-Chalabi

2001 CLK55
1999 Dodge Ram 2500 Cummins Diesel
2002 Harley-Davidson Fatboy
Merlin Extralight w/ Campy Record
Reply With Quote
  #5  
Old 01-28-2002, 10:06 PM
Registered User
 
Join Date: Sep 2001
Location: Austin, Tx
Posts: 713
hmmm... ok, I understand. But then that still leaves the question as to why my car is so much faster after a cold start... if the cold start valve is disengaged after the engine turns.... what is causing the increased performance. And, do you guys think that the benz under WOT could burn the extra gas? Just a thought...
Reply With Quote
  #6  
Old 01-29-2002, 12:44 AM
Registered User
 
Join Date: Apr 2000
Location: LEMONT-CHICAGO
Posts: 412
My 190e 2.6 does the same exact thing. It will get up and dance and smoke the tires when it's cold. I think the trannie kicks down and hold in first a little longer. I wish it would do it on command.
__________________
1990 190E 2.6
1996 Grand Voyager 3.3
1985 Mustang GT 5.0 5 SPD
1982 Suzuki GS 750T
Reply With Quote
  #7  
Old 01-29-2002, 01:08 AM
blackmercedes's Avatar
Just a guy
 
Join Date: Dec 2000
Location: St. Albert, Alberta, Canada
Posts: 3,492
Many more cold engine full throttle burn-outs, and it's won't be a supercharger you need. New engine...

I think it might be a combination of cold dense morning air and enriched mixture.
__________________
John Shellenberg
1998 C230 "Black Betty" 240K

http://img31.exs.cx/img31/4050/tophat6.gif
Reply With Quote
  #8  
Old 01-29-2002, 06:34 AM
Registered User
 
Join Date: Sep 2001
Location: Austin, Tx
Posts: 713
hmm.... I doubt it has anything to do with the air, because like I said, the car goes back into normal mode after you floor it once, the temp of the air didn't change, as it was 30 seconds later. I also doubt its first gear, as my car has first gear start. So, that just leaves enriched fuel mixture. Anyone know how it works? And is it possible to turn it on? Im not looking for a supercharger or anything, just a little tweak to performance. I would equate it to overclocking your computer, It brought a smile to my face when I got my 366 celes to run at 571 mhz instead of 550...
Reply With Quote
  #9  
Old 01-29-2002, 07:03 AM
LarryBible
Guest
 
Posts: n/a
It is a combination of the added richness AND the cold dense air that the engine is receiving. A gas engine is an air/fuel pump, as the amount of air AND fuel the engine pumps in increases, the power increases proportionally.

You should not drive ANY engine hard when it's cold, you are drastically decreasing engine life. If the engine is cold enough to run like this, the oil is nowhere near warm enough to circulate and do it's job properly at high RPM. I don't care what kind of super oil you use.

In race engines it is not uncommon for an engine to be lost after cooling down during a red flag period and then run hard immediately after restart. Cold oil is incapable of doing it's job properly.

Good luck,
Reply With Quote
  #10  
Old 01-29-2002, 08:08 AM
Registered User
 
Join Date: Sep 2001
Location: Austin, Tx
Posts: 713
Ok, I agree with your point about revving a cold engine, and that was the only time I did/am going to do it. But, is it possible to get added fuel richness on demand? Not just for the first 30 seconds of car operation perday?
Reply With Quote
  #11  
Old 01-29-2002, 10:03 AM
Registered User
 
Join Date: Jun 1999
Location: Surrey, Beautiful British Columbia, Canada
Posts: 750
are you guys sure you're fully awake during those mornings?
or are you still dreaming of an 8 cylinder car? he he
Reply With Quote
  #12  
Old 01-29-2002, 10:22 AM
blackmercedes's Avatar
Just a guy
 
Join Date: Dec 2000
Location: St. Albert, Alberta, Canada
Posts: 3,492
I think you might be missing the point. Larry and I are talking about WHY the enriched mixture would work at all, and that is due to the cold dense morning air. Just adding additional fuel through a richer mixture won't add power. You need more O2 molecules to go with the additional fuel.

It is a combination of the two things. If you rich the mix most of the time, it won't make much difference, maybe even make drivability worse. You'll wear plugs out faster, and probably not see any performance increase.

If you activate the cold start enrichment when the intake air is warm and less dense, you'll not make any improvement at all. BTW, your FI system is pretty well designed to optimize the mixture. If you truly monkey with it, you MIGHT be able to get a lttle boost on some occasions, and wreck it for the rest of the time you're driving.
__________________
John Shellenberg
1998 C230 "Black Betty" 240K

http://img31.exs.cx/img31/4050/tophat6.gif
Reply With Quote
  #13  
Old 01-29-2002, 01:19 PM
LarryBible
Guest
 
Posts: n/a
You possibly could gain a slight power increase by cheating the system to make it rich. The downside is all those that blackmercedes pointed out PLUS the worst one. That is that the rich condition will dillute the oil on the cylinder walls and lead to premature engine wear.

Have a great day,
Reply With Quote
  #14  
Old 01-29-2002, 01:41 PM
Indy300CE
Guest
 
Posts: n/a
This doesn't have anything to do with something as simple as 1st gear acceleration when cold and 2nd gear after the first shift through, would it?
Reply With Quote
  #15  
Old 01-29-2002, 01:57 PM
moedip
Guest
 
Posts: n/a
Crazy thought - could it be the viscosity of the oil when cold maybe giving slightly higher compression - then as the engine heats -the oil thins and compression goes to normal?? Just wondering

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
300E HARD TO START WHEN COLD walraven Tech Help 8 06-18-2008 12:54 PM
300e Fuel Dist., Air Fuel Meter, Cold Start, Idle Control Valve Low190eBenz Mercedes-Benz Cars For Sale 0 02-11-2003 05:08 PM
380SE - High fuel consumption : Diagnosing the Cold Start Valve amit Tech Help 3 01-24-2003 06:29 PM
No Start When Cold McRoth Diesel Discussion 13 12-25-2002 10:46 PM
300e hot start problem Tom Garrison Tech Help 4 08-14-2002 09:21 AM



All times are GMT -4. The time now is 02:01 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page