how to access a/c diagnostic codes from the pushbutton display console
I have a 92 300se that all of a sudden, the a/c clutch cycles after a cold startup after about 5 minutes, then it will cycle every 10-15 seconds. Then freon is full, this started right after a wire broke off the terminal at the compressor but was fixed ( resoldered the wire back on to the connector). What may be the cause of this and what buttons on the consloe do i need to push to go into diagnostic mode? Any help would be greatly appreciated.
|
All times are GMT -4. The time now is 10:56 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website