|
|
|
#1
|
||||
|
||||
need wire diagram for under seat vac pump
My lock quit working so I pull vac pump motor and tested.In the process unpluging the wires the longer plug went to pieces, the wires fell out of plug. I finally found problem was a door switch. But can't test until I can find wire diagrom. I searched for 3 days.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran |
#2
|
||||
|
||||
Need to know what car you are working on.
__________________
Click here to see the items I have up for auction at EBay Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold) |
#3
|
||||
|
||||
99 s320
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran |
#4
|
|||
|
|||
New to the forum so I hope this is ok to start here. My central locking system stopped working also. Different vehicle though, 88 560 SEL. I do not even hear the pump which I think is located in the trunk. Just not sure where. I can only manually unlock driver and passenger doors with key. Where should I start to trace the problem from. Thanks in advance for any help / solution.
__________________
Jacamo9 1988 560SEL (223k daily driver) |
#5
|
||||
|
||||
my drivers door switch was to blame.
door switch gets worn out.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran |
#6
|
||||
|
||||
fixed
from bits,and photos, I managed to rewire the vac pump,I now have locks.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran Last edited by oldsinner111; 03-05-2013 at 04:50 PM. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|