Exhaust Manifold Leak
I have a leak from #4 cylinder exhaust manifold port on my E200.
I took off the manifold, lost a tea-spoon of O positive in the process, :( and found it seems to "rock" on the centre ports where it mates against the head. So when I fit it back, the centre two fit well, but either #1 or #4 do not. There is about half a millimetre gap at either end where it should bolt down to the head. Is this normal? I've tightened up the nuts to the correct torque but still #4 blows just a tad. I guess if I tightened up #4 first then #1 would blow. Do I need a new manifold? Or can I get the mating surface machined off from the centre two arms? or should I fit an extra gasket at each end? Any ideas guys? E200 Wagon '94 M111 engine. 109k miles |
I would get it machined. Then re-fit it and see how it goes.
|
Thanks Benzmac.
Much obliged. Barry |
All times are GMT -4. The time now is 10:27 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website