|
|
|
|
|
#1
03-17-2002, 08:41 PM
|
||||
|
||||
Control Arm Bushings Are Shot!!!
My control arm bushing are so bad my 87 300E goes "clunk" whenever i turn the wheel. My tech said he will replace them and my tie rods because they are going bad as well. How many hours(without alignment) does this intial? What is the usual labor cost of this job? Is there anything else i should have him look at or replace while he's in there? Your comments will be greatly appreciated!
Thanks! Adam
__________________
Current Stable: 01 ML55 AMG 92 500E (a few mods) 87 300E (lots of mods) 00 Chevy 3500HD Diesel Box Truck 68 18' Donzi Marine  06 GT i-Drive7 1.0 Mountain Bike (with GPS!  )PREVIOUSLY OWNED:83 300SD, 87 420SEL, 88 420SEL, 90 420SEL, 86 560SEL, 86 190E 2.3-16V AMG, 94 E320 
Last edited by ADAM BOURASSA; 03-17-2002 at 09:11 PM. 
|
|
#2
03-17-2002, 09:49 PM
|
|||
|
|||
|
We usually get 2.4 hrs per side and .5 per tie rod. So about 5.8 for the full job minus alignment. Make sure you get a four wheel alignment.
__________________
euro 287 Mercedes Technician 7 Years (retired to Hyundai) 2000 Dodge Durango 98 Mazda truck
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '95 E300 Front Control Arm Bushings | pberku | Diesel Discussion | 3 | 12-15-2004 11:02 AM |
| Help- W124 control arm bushings | samiam4 | Tech Help | 0 | 10-12-2004 08:14 PM |
| Anyone ever replaced upper control arm bushings on w116? | WANT '71 280SEL | Diesel Discussion | 6 | 11-15-2003 01:03 PM |
| front lower control arm bushings | gstwood | Tech Help | 0 | 10-25-2003 06:14 PM |
| Control Arm Bushings | lyndongt | Tech Help | 1 | 02-09-2002 09:45 PM |
Linear Mode
