|
|
|
#1
|
|||
|
|||
86 300E wont start on first cold day.
Today was the first cold day since I bought this car a month ago and this morning it wont start. It went down to the mid 20s while previously it has started fine in the upper 40s. I have noticed two symptoms previously, first, it would have a high idle for 20 to 30 minutes after starting cold(even after the engine was fully warmed up), and second, it would feel sluggish accelerating below 2000 rpm. I have replaced or checked the following: new plugs(Bosch copper), new plug wires, new cap and rotor, checked coil primary and secondary resistance(both in spec), checked for spark from coil wire to a ground(seems fine), checked crank sensor resistance(in spec), checked coolant temp sensor(both terminals at sensor in spec at 6K ohms at 30F), checked 4-pin temp sensor connector at ignition module and found the following: pin 1 to ground 6K ohms, pin 2-3 700 ohms, pin 1-4 infinity, and pin 4 to ground infinity(could this be right?, isnt pin 4 a ground?) checked OVP relay and fuse(fuse is fine and relay is dated 1997), engine cranks at normal speed. Pulled the plugs and they were wet with gas from all the cranking so I know its getting fuel. Leaning towards ignition problem since using starting fluid has no significant effect when cranking. Could the coil be bad even if the resistance is in spec and produces sparks? Could the ignition module be bad even if the coil makes sparks and is there a way to test it? Any other temperature related sensor to check? It should get back to the 50s this weekend so Ill wait until then to start it. Any suggestions?
|
#2
|
|||
|
|||
Forgot to mention the car has 150,000 miles.
|
#3
|
|||
|
|||
I couldn't believe it! My car quit too. I read your post and was sympathetic but at the same time feeling good because my car hasn't ever let me down in 11 months of ownership. THEN NOTHING!!!
We are kindred spirits now. Mine cranks over but no life. I'm checking for spark and fuel soon. It's been raining like crazy here and I suspect that the electronics got wet. Good luck to us both.
__________________
VR 1967 250SL |
#4
|
|||
|
|||
Well, I hope you are as lucky as me. I went out to check my car tonight. Grounded the #1 spark plug against the exhaust manifold while my daughter ran the ignition switch. Good looking spark. Then checked #1 plug for fuel wetness. Dry. I knew that I had a spare fuel pump relay so I tried that. It fired right up. I took the old one apart and found a bad looking solder joint at one of the pins. I'm going to solder it again to see if it repairs it.
Like I said, I hope you are as lucky!
__________________
VR 1967 250SL |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300e Where is the cold start injector/ How do I disable | smileymikey | Tech Help | 5 | 08-11-2004 09:24 PM |
cold start hell | GDJ | Tech Help | 0 | 01-08-2004 07:05 PM |
86 300E hard to start when cold | lmtracer | Tech Help | 1 | 07-30-2003 11:28 AM |
1992 300e Cold Start Problem | jmraia | Tech Help | 2 | 02-27-2000 01:13 PM |
Difficult Cold Start, 1989 300E | cgraves | Tech Help | 3 | 08-03-1999 08:09 PM |