|
|
|
|
|
#1
04-19-2002, 11:44 AM
|
|||
|
|||
|
Head R&R
About how many hours labor does it usually take (barring any unforseen difficulties) to just R&R the heads on a M116? This isn't by any means a DIY job is it? Going along with that, how do I know whether my engine just needs a top end opposed to an entire rebuilt engine? Or is it worth JUST doing the top end and leaving the bottom? I have heard that the bottom ends of these cars are pretty stout. Any advice is appreciated.
__________________
'86 420SE Euro 904 Midnight Blue, Gray Velour Dad bought it new, now I own it. "A Mercedes-Benz is like a fine wine, it only gets better with age." 
|
|
#2
04-19-2002, 04:00 PM
|
||||
|
||||
|
Have you tried replacing the valve stem seals? Quick, cheap and easy and just might solve the problem.
Pulling the heads is within the DIY realm. The only special tools you absolutely need are offset socket bit for the cylinder head bolts and some way to pull the chain guide rail pins. It's probably worth replacing the water pump and lower end of the timing chain while you have the heads off. Sixto 91 300SE 87 300SDL 81 300SD 78 450SEL (sold)
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cylinder head trouble | xp190 | Tech Help | 10 | 06-23-2004 02:19 PM |
| '84 500 SEL 117.963 cyl head R&R anxiety | dloveless | Tech Help | 2 | 10-20-2003 03:30 PM |
| C280 Head Gasket R&R | armandotrans | Tech Help | 10 | 01-11-2003 02:08 PM |
| Sharing experience with cylinder head on 103 motor (1986 300e) | marinmbfan | Tech Help | 13 | 08-06-2002 05:34 PM |
| Cracked Head 260E | Scotty | Tech Help | 5 | 03-02-2002 10:47 PM |
Linear Mode
