300E Brake Discs
 

I have removed the calipers, but I cannot get the discs to come off. I have removed the upper and lower bolts, and the 5mm hex, but they won't budge. I did also remove the push sleeves, and still nothing. Do I need to rent a puller? Please help!


Brian :confused:

WD 40 and...
 

good rubber hammer:D

HMMMMMMMM!
 

The e-brake is not on is it ?

How to squeeze the calipers
 

Most of the manuals suggest that when replacing the pads, you squeeze the piston on the caliper back with a pair of slipjoint pliers. This is hard to do, and if you can't get the piston squeezed all the way back the pads won't fit back on the rotor disk.

What to do?

USE A SIMPLE C-CLAMP! A common 4 inch screw up C clamp is the ideal tool, and has enough leverage that you will be able to easily screw the caliper piston back easily. Open up the clamp, put it as close to the center of the piston as you can, and screw it down.

The rotor wil probably come off with an application of WD-40 and a sharp rap with a rubber hammer. If you do not possesss a rubber hammer, put a piece of wood (at least 2 in long or thick) against the rotor and rap it in several places around the rim with a regular hammer, always cushioning the blow with the wood.

Remember those rotors were put on by Helmut Hans Schtreubelmacker, and he was much stronger than you are. After that, they were tightented by repeated coolings and heatings for many many kilometers. (as we know, a Mercedes always thinks in kilometers).