|
|
|
#1
|
|||
|
|||
power headrest problems
i've got a problem with my drivers headrest.the seat functions fine except for the power headrest.i can't get it to go up or down.is this in sync with the shoulder belt height?
__________________
'95 s500 (bought for wife but can't bear to share!!!) 125kms '92 legend 180kms '88 tbirdturbo(fantastic car-only regular maint.)120kms '87 mustang gt(gone) '86 tbirdturbo(gone) '85 mustang gt(gone-but not forgotten) |
#2
|
|||
|
|||
Can you hear the motor working inside the seatback? The driver side works on my 89 300E, but not the passenger. I have followed the owner's manual instructions for pulling the headrests out (hidden release button in seatback) thinking that maybe it could then reconnect, but can't pull either side.
I know this doesn't help you, but maybe someone else will help both of us. Good luck.
__________________
Jim Wiggin Columbus, OH 1989 300E |
#3
|
|||
|
|||
On the other hand, just like the first message says, "Use the Search."
I searched for "headrest" and came up with several good discussions on removing seatback panels in order to mess with the headrest mechanisms. I'll explore tomorrow. Good luck.
__________________
Jim Wiggin Columbus, OH 1989 300E |
#4
|
||||
|
||||
DO NOT TAKE THE SEAT APART!!
I will check the seat adjustment switch first. You can take the switch apart and clean the contacts with sand paper and spray some WD-40 before you put it back together
__________________
Peter Chu aka PIKACHU 08 C300 Premium Pkg, MM Pkg, Sport Pkg, Keyless Go 86 300E soon to be E36 with Euro Headlights 400E front & rear brake upgrade 16" CLK wheels with Michelin MXV4 plus Green X |
#5
|
|||
|
|||
chupr98!!
how do you take apart the seat switch.mine is on the door in the shape of the seat.is yours the same?
__________________
'95 s500 (bought for wife but can't bear to share!!!) 125kms '92 legend 180kms '88 tbirdturbo(fantastic car-only regular maint.)120kms '87 mustang gt(gone) '86 tbirdturbo(gone) '85 mustang gt(gone-but not forgotten) |
#6
|
||||
|
||||
Carefully pry the plastic trim around the switch off, then you will need a 10mm socket to remove the door handle bolt. The switch will come out but sliding it forward it towards the front. Remove a philips screw, the switch is snapped together. Be careful of the ball bearings, don't lose them!!
Good luck!
__________________
Peter Chu aka PIKACHU 08 C300 Premium Pkg, MM Pkg, Sport Pkg, Keyless Go 86 300E soon to be E36 with Euro Headlights 400E front & rear brake upgrade 16" CLK wheels with Michelin MXV4 plus Green X |
Bookmarks |
|
|