|
|
|
#1
|
|||
|
|||
Zenith 35/40 INAT disassembly question
I have two Zenith 35/40 INAT carbuetors to rebuild. While disassembling the first one, I had no problem until I tried to seperate the top section from the float boal section. I have re, re, re confirmed that I have removed all the screws, but they will not come apart? I tried using a little extra force by tapping a flat blade screw driver inbetween, and lightly prying...did not work. I am real hesitant to pry harder and possibly break the sections. Is there some trick to seperating these sections? Thank you in advance.
|
#2
|
|||
|
|||
My original post was in error. After looking harder, I found that there is a screw in located approximately in the center of the carburetor that is recessed so far into the carburetor that I could not see it. I tried using a small flat screwdriver to see if there was anything in there...to my surprise there was a flat head screw in there. After removing it, the carburetor fell apart. I feel stupid, but if this post helps someone else in a similar situation...it is worth it.
|
Bookmarks |
|
|