|
|
|
#16
|
|||
|
|||
I do have a/c however the fenale plug on the wire is only for 2 pins.
I have no idea about whether its a cosworth. Do you mean use the start valve shut off that had a part number given in here? Otherwise i don't know what bosh part i was directed too. |
#17
|
|||
|
|||
PM sent
|
#18
|
|||
|
|||
Just buy the 3 pole switch and use only the 2 pin connector, don't use the third pole , part number should be on switch, the red temp switch at water pump is for 2nd stage activation when car is too hot,SWITCH "h" IS THE ONE YOU WANT
|
#19
|
||||
|
||||
No. 4 on the scheme.
|
#20
|
||||
|
||||
P/n is A 006 545 39 24.
|
#21
|
|||
|
|||
dr sternschnuppe: # 4 is the temp switch for the gauge. #1 is the gauge I need which is confirmed with a continuity test.
here's a link to my source. http://www.startekinfo.com/StarTek/outside/11832/Resources/201Create/PDF/30003.pdf It's the startek online manual I got from these fourms. The link will take you to the crank case section. The description starts on page 01-416 which you can click on the left side menu. It's a good picture of the location followed by a picture of each sensor. This is for the 201.024 model with the 102.961 engine which is only on the '84 190e that I've found. |
#23
|
||||
|
||||
Temp. switch for the aux fan located at the water pump.
P/n A 006 545 39 24 or A 006 545 14 24. #41 on the scheme. Last edited by Dr. Sternschnuppe; 10-23-2015 at 05:05 PM. |
Bookmarks |
|
|