Hi everyone, I am new to this site. I have a 1990 300e 24v problem I have is, it starts ok runs for about 15 mns then stops, I have to strip the injection system down and dry out the manifold,it fills with fuel till it blocks the manifold passage ways, .Idears please . Frank in the UK

Is there a vacuum line running from the fuel pressure regulator to the intake plenum? If so, see if this is full of fuel, which would indicate a ruptured diaphragm in the regulator = replace.

__________________

Gone to the dark side

- Jeff

Thanks for the reply, that vacuum pipe is clear,I am getting good at striping the injection down to drain the air intakes, but am no closer to finding an answer