|
|
|
#1
|
|||
|
|||
Power seat switch '90 300 SE
My passenger power seat control switch doesn't work in the forward direction. The motors are OK because pressing the memory button causes the seat to move forward...and all of the other directions work ok when I manually push the switch in all of the other directions.
I'm thinking the forward contacts on the switch are dirty. How do I go about getting to the inside (or back) of the switch? The switch assembly is in the middle of a wood grain trim piece. Does the whole door panel need to come off, or is there a way to get the woodgrain piece off? Am I even barking up the right tree here? (is it likely to be something something other than the switch? Thanks, folks |
#2
|
||||
|
||||
TRICKY BALL BEARINGS
Carefully pry the trim off around the switch, remove the 10mm bolt, slide the assembly forward and it will come out.
Be careful do not lose the ball bearing when you open the switch. Lightly sand all contacts and spray some WD40 on them. You need some luck in order to snap the switch back in 1 try!! Good luck!
__________________
Peter Chu aka PIKACHU 08 C300 Premium Pkg, MM Pkg, Sport Pkg, Keyless Go 86 300E soon to be E36 with Euro Headlights 400E front & rear brake upgrade 16" CLK wheels with Michelin MXV4 plus Green X |
Bookmarks |
|
|