I'm in the process of removing an old cell phone. I've got everything out except for the mic, which is attached to the winshield pilar. How does one remove the trim? I tried removing the screww at the top where the visoe meets, but it didnt seem to do much.

On the Becker radio, the single (thick) wire next to the four-prong power plug, is it the power antenna lead?

THe right side mirror doesn't tilt high enough when using the switch--it just clicks after moving so far. I'm thinking that the mirror needs to be re-adjusted on its mount. Someone told me to wrap a rag around a screwdriver, insert it under the outside edge of the mirror, and pop it out. Is the this the preferred method--I tried using a rag/putty knife combination, but it didn't act like it was going to work, and I was afraid of breaking the mirror. Any suggetions?

Bob Cavazos

The trim has a few screws holding it in. Some are on the bottom. The wire you asked of is the wire for the power antenna. The mirror may have clip on the back side of it so be careful not to break it. Pry it back and look for the clip.

------------------
Benzmac:
ASE CERTIFIED MASTER AUTO TECHNICIAN
LEAD TECHNICIAN FOR 14 BAY FACILITY
MERCEDES SPECIALIST 8 YRS
PARTNER IN MERCEDESSHOP.COM