|
|
|
|
|
#2
06-07-2002, 10:34 PM
|
||||
|
||||
|
The filter is above a plastic panel that is in front of the left rear wheel. There are 2 plastic nuts at the front of the panel and one at the rear. Remove the panel and you'll see the filter. there are 4 hoses running to it, 2 front, 2 rear. One of the hoses is a press fit and can be easily pulled off by hand. The other 3 are retained by clamps. MB uses a crimp clamp, these I dispense with in favor of common worm-gear clamps. The crimp clamps can be unclipped with a small screwdriver. The filter is clamped into place with a fairly simple sheet metal clamping bracket, just looen the phillips screw to loosen the filter from the bracket.
Gilly
__________________
Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold) 
|
 |
| Bookmarks |
|
|
Linear Mode
