PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   rear shock absorber change. (http://www.peachparts.com/shopforum/tech-help/41074-rear-shock-absorber-change.html)

TurboTurbine 06-27-2002 08:05 PM

rear shock absorber change.
 
Has any one here recently changed their rear shock absorbers on a 1985 300D. how involved is the job and are there any special tools or techniques needed?

Palangi 06-28-2002 09:52 PM

Not difficult. No special tools needed. The rear seat has to be removed. That might require a helper as its a bit akward.

haasman 06-29-2002 02:00 AM

The reason you need to remove the rear seat (cushion and seat back) is to gain access to the top of the shocks.

The seat back is held in by 10 mm bolts in the center and two outboard areas, left and right. The seat back is removed by lifting straight up. Be careful when removing it from the car because the lower "arms" can VERY easily scratch paint.

Once the seat back is removed you will need to remove an insulation pad (easy). Then you will notice two white plastic covers. Pry them off and you will see the top of the shocks. In order to remove the shock you will need to remove the two nuts. Sorry I am not sure but I think they are 14 mm. Since the second (lower nut) will want to turn with the shock, you will need to use a small crescent wrench or other tool to hold the shock shaft at the top.

Once this is done go to the bottoms. It is much easier to do this by jacking the car up. The lower portion of the shock is held in place by one bolt.

Installation is simply in the reverse order.

Hope this helps.


All times are GMT -4. The time now is 12:34 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website