|
|
|
#1
|
|||
|
|||
Ball joint pins won’t go in strut
Ball joints were a pain. But finally got the old ones out and new ones in. Honestly the thing I’m having most trouble with is getting the pins back into the strut housing. Anything I’m overlooking? I’m basically just pushing the arms up with a Jack into the housing. Pin starts going in then stops.
I’ve cleaned out the hole in the strut. The pin. Tried a little grease. Up. Down. Up. Hammer. Whatever. Using lemforder ball joints. Anyone else run into this? |
#2
|
|||
|
|||
Never mind! I ended up having to take off the rotor, and removing the entire hub from the car essentially. Then I placed it on the ball joint. What a pain.
|
Bookmarks |
|
|