Technical Data for M103 engine needed
I am trying to decide whether to buy standard or undersized main and connecting rod bearings. I have the clearances measured off of my crank but I do not know the specifications of the bearings. Can anyone help me out with this information?
|
Unless you plan on turning the crank, use standard bearings. Have you mic'ed and found the journals in spec?
I have the dimensions at home if you need to know the original journal size. Good luck, |
The main bearing journals were about 2.3065" and the rod bearings were about 1.8875". Should I still go with the standard bearings? The engine had a 104,000 miles on it.
|
All times are GMT -4. The time now is 04:13 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website