|
|
|
#1
|
||||
|
||||
M112, M113 oil cooler hoses
Working on replacing water pump on 98 E320. It has an oil cooler.
I wondered if anyone might have a new or old connector hose that they could measure. The part number is 1122030382. There are two and they are shown in the attachment (items 83 and 71) I just need the one at the pump. Reason for request, is that I can't find the MB hose in Canada. Amazon have a URO, but they say it is .595" (15.113mm) ID. I have 200psi 5/8" heater hose that is 0.625" ID (15.875") and despite being bigger than the URO, it is a very tight fit and may be hard to install. My originals are still on car, but may have to be cut to remove. Before I do that I want to be sure I have replacements! I realize this is a long shot request
__________________
Graham 85 300D,72 350SL, 98 E320, Outback 2.5 |
#2
|
||||
|
||||
Ignore above request - I got the old hose off without damage.
__________________
Graham 85 300D,72 350SL, 98 E320, Outback 2.5 |
#3
|
||||
|
||||
By the way, I bought a thinner walled 5/8" heater hose that has the same dimensions as the original hose (the 200psi hose I had was too stiff and larger in diameter) Couple of bucks for a foot! I switched to gear clamps because this hose didn't seal with the original spring clamps.
__________________
Graham 85 300D,72 350SL, 98 E320, Outback 2.5 Last edited by Graham; 03-27-2023 at 09:34 AM. |
#4
|
|||
|
|||
Are you saying a local dealer cannot supply the correct hose?
|
#5
|
||||
|
||||
Yes. That little hose is apparently NLA from MB. Only source seemed to be URO. Their hose was not in stock here and besides, cost was about $15 for 2" of what is just 5/8" heater hose. Which is what I used.
__________________
Graham 85 300D,72 350SL, 98 E320, Outback 2.5 |
Bookmarks |
|
|