I am trying to check out the wiring that is plugged to the injectors ---what reading should I be getting across the plug when I crank the engine
------------------ syd 81.300SD 72.300SEL 4.5 |
There is a "voltage" frequency sent by the computer to the injectors. The injectors are triggered in pairs by 4 sets of points(mounted in the bottom of the distributor).
|
this engine runs--misfires and is rough--- like it is not running on all cylinders---plugs are black ---have replaced plugs --new air filter---checked points ---checked all plug leads nicks and the suchlike also for resistance--checking timing and compressions tomorrow ------trying to figure out if there are any problems with the wiring to the injectors---have dicovered tonight that when pulling plug off injectors corrosion is very visable---so will clean them as well---any advice would be apprecciated ---need this engine up and running to see if rest of car works it was delivered to me on a low loader
------------------ syd 81.300SD 72.300SEL 4.5 |
Hi,
Pull the distributor and check for oil on the trigger-points in the distributor base. You can also trace the problem on a scope. The injectors are fired in the following pairs: #1&5, 2&7, 3&6, 4&8. Usually when you see a problem on any of these pairs of cylinders...it's trigger-points. Regards, Randy D. ------------------ W.R.Durrance ASE Master Tech Mercedes Tech 19 Years |
Now that you have described the running problem as running rich I'll bet that the cold start relay is stuck, un plug the cold start valve & see if the engine runs better. Also the vacuum hose for the M.A.P. sensor has been known to leak.
|
thank you for all answers I received on this topic syd
------------------ syd 81.300SD 72.300SEL 4.5 |
whilst I'm running rich I was spitting and banging and could not rev it up--all injector boots disintergrated and all injector plugs were coroded--(think its been standing a long time)no5 was welded solid with corosion --I am waiting for new injector plugs to be delivered---tried to get workshop manual from 1-800-for-merc --no luck --got told the old cd story--QUESTION --so M.B.DOC help me out here---- where is the cold start valve and the M.A.P.sensor--I feel I will have to replace N05 injector --but as soon as plugs arrive I will try it before replacing it
------------------ syd 81.300SD 72.300SEL 4.5 |
All times are GMT -4. The time now is 08:55 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website