Need some help!
 

I have the drivers door apart on my 420 sel. Replacing the window reg. Got the old one out (no problems) ready to put the new one in. The window is resting at the bottom inside the door. I raise it up and a nylon slide falls off the lower left corner of the window. I didnt see how it was placed on the window. Can someone explain in words how it rests on the window. It's early here in Sacramento on Saturday and want to finish the job.....Anyones help will be greatly appreciated......
:confused:

Any way you can post a pic?

picture
 

I'm so new at posting on this bb, I have not had a chance to play with posting pictures....however that would be of great help. I have my comp set to do that with dig video and all but have not had time to play with it. I probably will have to pull the other side off to compare as much as I dont want to......know what I mean?

Dave:

I found some decent threads, some with pictures, that seem to discuss what you are asking. Hope they help.

http://www.peachparts.com/shopforum/diesel-discussion/42803-sliding-window-jaw.html?highlight=window+plastic
http://www.peachparts.com/shopforum/diesel-discussion/41071-my-first-paying-car-repair-job.html?highlight=window+plastic
http://www.peachparts.com/shopforum/tech-help/37431-w140-rear-left-window-problem.html?highlight=window+plastic
http://www.peachparts.com/shopforum/tech-help/8963-replacing-window-sliding-jaw.html?highlight=window+plastic+slide

http://www.mindspring.com/~houlihan/merc/regulator.htm

thanks john
 

I appreciate the treads. Answered one of the questions. I think I can figure out the rest with common sense.....thanks so much for the feed back.

Dave Bunker