I am having to replace all the plugs that that plug into the injectors--there are two wires to each injector one is brown the other could be a gray (it is not brown)which goes two the left hand pin on the injector---thanks for all answers syd

------------------
syd 81.300SD.196k
72.300SEL 4.5
mileage only god knows



[This message has been edited by SYDDONNA (edited 06-24-99).]

Since the injector is operated by the power creating a "field" magnet the + & - isn't as important as the quality of the connections.

M.B.DOC Thanks for answer--these were originaly crimped connections-- As I dont have the needed tool---- I intend to solder these connections ( wires too female pins)---QUESTION would this give me the quality of connection you indicate in you reply---thanks --syd

[This message has been edited by SYDDONNA (edited 06-24-99).]

Try an electronics store for crimping pliers, maybe even Radio Shack. Crimping & then soldering would work best

M.B.DOC will do ---as usual great answers--as well as some useful theory ---thanks syd

------------------
syd 81.300SD.196k
72.300SEL 4.5
mileage.Only god knows!