Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 09-13-2002, 12:40 AM
OneBadViper's Avatar
0-100, back to 0 in 13Sec
 
Join Date: Feb 2002
Location: Way Down South
Posts: 143
Question S500 Door Closers Not closing drivers door??

My 94' S500 drivers door closer stops working. To make it start working again, I have to remove the #9 fuse & re-install then it works for a while and quits again. The trunk does the same thing. What is the cause of this?

Reply With Quote
  #2  
Old 09-13-2002, 01:24 AM
Registered User
 
Join Date: Apr 2002
Location: Calgary, Canada
Posts: 164
If it happens once, it could have been something stuck in the door.

If it happens often, then you need a new vacuum pump. There is some sort of lock-out that disables the pump if it hasn't seen the microswitch in a certain amount of time.

This is a common problem with these cars. Like I saw in a previous post, keep following the Reset procedure until it annoys the heck out of you, then its time to replace the pump.

BTW, mine's been doing the same thing for some time. Haven't broken down to get a new pump yet...mucho $$$ up here in Canada.
__________________
Dave

1995 S320
Reply With Quote
  #3  
Old 09-13-2002, 06:41 AM
Gilly's Avatar
Registered User
 
Join Date: Mar 2001
Location: Evansville WI
Posts: 9,616
This is the safety shut-off feature. It's not neccesarily a bad pump. It can also be a vacuum leak in the system which is no longer working.

Gilly
Reply With Quote
  #4  
Old 09-13-2002, 08:50 AM
it leaks, its german
 
Join Date: Mar 2002
Location: raleigh nc
Posts: 1,111
Things to check.

vacum leaks, actuator, lines etc.
micro switchs in latch assembly, they will stick and fail to signal the pump that the door is now shut.
trunk latch, loose latchs will allow the trunk assist to keep pulling on it, thereby shutting the pump down.
shutting the door on the seatbelt is a surefire way to shut the pump down too.

I've replaced several latchs in these for this problem, make sure the l/f is the only door shutting down.


Joe
__________________
Project Smoker, '87 603 powered wagon
Hauler, 96 CTD can you say torque?
Toy 73 Cougar xr7 convertible
Acme Automotive Inc.
Raleigh NC
919-881-0364
Reply With Quote
  #5  
Old 09-13-2002, 11:50 AM
OneBadViper's Avatar
0-100, back to 0 in 13Sec
 
Join Date: Feb 2002
Location: Way Down South
Posts: 143
Question S500 DOOR CLOSERS NOT CLOSING???

Thanks for the reply. Let me tell you a couple of more things about this problem. BOTH FRONT doors are doing the same thing. The rear doors do not seem to have a problem. I can pull the fuse as a reset, and all might be fine for another 2-3 closings. Now, if the drivers door fails to close, that does not meen the right door is not closing. Sometimes it might take it longer to stop working??? Many have said it's the vaccumn pump under the rear seat because it operates all four doors each by themselves and the two front doors are used the most so that circut fails first? Does this same pump operate the trunk? Sometimes it's fails to pull down and I reset by pulling the fuse, then it's fine for a while??? If it is the vaccumn pump, are they expensive and can I install it myself?

Thanks again,
Warren
Reply With Quote
  #6  
Old 09-13-2002, 12:06 PM
Registered User
 
Join Date: Jun 2002
Location: Conway, SC
Posts: 319
The pump under the rear seat is the central locking pump. The pump for closing assist is located in the trunk on the leftside just forward of the front trim panel.The most common problrm with this system is the pump ,but it is possible it could be a bad door latch element or micro switch.The only way to know for sure is to test the pressure and electrical portions of the system.
__________________
Mercedes Benz Master Tech - Retired
Reply With Quote
  #7  
Old 09-13-2002, 04:43 PM
Registered User
 
Join Date: Jul 2002
Posts: 18
I had my right rear door apart to re-install the door handle that fell off due to the mounting screw backing off. None of the door closure have worked ever since. The trunk closure still works. Is it possible that I inadvertantly disconnected something?
Reply With Quote
  #8  
Old 09-13-2002, 05:22 PM
Registered User
 
Join Date: Mar 2002
Location: Great White North!!!!
Posts: 400
keitharm

repost as a seperate subject

__________________
'95 s500 (bought for wife but can't bear to share!!!) 125kms
'92 legend 180kms
'88 tbirdturbo(fantastic car-only regular maint.)120kms
'87 mustang gt(gone)
'86 tbirdturbo(gone)
'85 mustang gt(gone-but not forgotten)
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 06:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page