brake job, suspension ?s, w124 94E320
I was ordering pads and rotors for our 94 wagon and was asked whether my rear brakes were one-pin or two-pin? anybody know?
Also, with 120k miles should I be doing anything about the bearings at this time? Grease or replace? Or are front bearings a job for a pro? While I'm at it, a quarter-size rust bubble is growing under the paint just above the plastic bumper about 5 inches in front of the right front fender well (halfway to the headlight). The PO receipts indicate he and the MB dealer repaired this spot twice. Seems odd to me--could it indicate a replaced fender due to a (gasp) wreck? And might a wreck explain why the car crabs (the front tracks 1/2 inch left of the rear) even after an MB dealer alignment last november. Since then the car ate a set of Mich tires in 20k miles, with severe wear on the outer edge of the right front tire. I've read lots about these suspensions--people replacing everything in sight--so I plan to have it checked out at several shops. Last, can't wait until Stu Ritter's new manual arrives in my mail. |
All times are GMT -4. The time now is 12:14 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website