|
|
|
|
|
#1
08-04-1999, 12:31 PM
|
|||
|
|||
|
Please dont laugh. (83 240D) Crankshaft pulley reads 30-20-10-0(TDC)-10-20-30-40-50
Clockwise. Engine spins clockwise. Is 24 BTDC to the right of the 0(TDC) mark, or left? I think I mistimed my engine!! |
|
#2
08-04-1999, 09:38 PM
|
|||
|
|||
|
if the pulley is turning C/W as your standing in front of the vehicle facing the engine then BTDC is on the RIGHT of TDC
30 20 10 TDC 10 20 * 30 spinning----> * IS WERE THE 24' MARK IS Okay, Chris C. |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is 22 BTDC timing ok? | diesellieber | Diesel Discussion | 12 | 09-08-2004 11:23 PM |
| US report pins down bogus degrees | GermanStar | Off-Topic Discussion | 5 | 05-13-2004 06:03 PM |
| Is a 75 degrees BEHR ThermoStat OK | blueriomedina | Tech Help | 3 | 12-20-2003 02:41 AM |
| Problems to start engine when hot. No problem when cold (below 80 degrees C) | pfgjerpe | Tech Help | 7 | 09-16-2002 12:02 PM |
| Hood opens only to about 55 degrees | TurboTurbine | Tech Help | 8 | 10-02-2001 12:03 AM |
Linear Mode
