|
|
|
#1
|
|||
|
|||
still no ignition
1992 500sl What pin in test connector at EZL will be hot with key in run position? Is there a way to test the crankshaft p[osition sensor?
|
#2
|
|||
|
|||
Crank sensor
Hi the crank sensor can be tested w/ohm test but the best way, that will also test pins on flywheel is w/waveform viewer. With a waveform viewer you unplug sensor and hook straight to it. I use a Snap-on Vantage. Some Digital Ohm meters will work. Hope this helps I'm working on a no spark problem w/91 500 right now that's giving me fits because every signal is there at the ignition module, but I cannot get codes from the ECU so I do notthink these two are talking to each other, Well good luck
|
Bookmarks |
|
|