|
|
|
#1
|
|||
|
|||
Not enough heat in 560sec -88
I doesnt get enough heat in my 560 sec.... the engine heat is ok but if its cold outside (and thats ofen here in sweden) and i drive about 100km/h it doesnt blow warm... if i drive slow its warm and nice in the car but not when i drive faster... It isnt the monovalve problem ... it doesnt blow icecold just not warm enough...
any ideas.... thanks...
__________________
--------------------------------------- -88 560SEC -77 280SE -71 Mercury Cougar Convertible -84 GMC Pickup |
#2
|
|||
|
|||
i have had that problem... and change it... but when i had that prob it started to blow icecold in the car... now its not icecold... its not COLD but its not warm enough..... if you understand...
there is no probs if its -0 till -8C but if its up to -12 to -20C the car isnt nice to sit in..
__________________
--------------------------------------- -88 560SEC -77 280SE -71 Mercury Cougar Convertible -84 GMC Pickup |
#3
|
|||
|
|||
I can allso say that the fan goes down in speed, so it "understand" that it could not hold the right temp, and when i slow down... the fan starts and it gets warm and nice...
__________________
--------------------------------------- -88 560SEC -77 280SE -71 Mercury Cougar Convertible -84 GMC Pickup |
#4
|
|||
|
|||
If the Auxiliary water pump is not running it can also cause this problem
|
#5
|
|||
|
|||
ok... were does i found that an how do i check it??
__________________
--------------------------------------- -88 560SEC -77 280SE -71 Mercury Cougar Convertible -84 GMC Pickup |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|