![]() |
C280 will only start after cooling
I have a 1995 C280 and have had no problems until yesterday when I parked it and came out a few minutes later and It would not start-turned over fine, but would not fire. After opening the hood and letting it cool off(engine running temp is fine) for a few minutes it started right up. I then drove it home, parked it,and attempted to start it with the same results- No start until cool again. Any ideas?
|
The "famous" over-voltage relay 000-540-52-45 can cause this problem. Replacement is 000-540-67-45.
Also the crankshaft position sensor at the flywheel can cause thie problem. would need to be tested when the car WON'T start. |
Thanks for the quick reply, thought It might be the OVP-but wanted the post's thoughts. I'll check the part number and change it if its the 'bad one" and go from there. Thanks again.
|
All times are GMT -4. The time now is 09:58 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website