|
|
|
#1
|
|||
|
|||
Valve Clearance Specs on 1973 350SE?
I am looking for the specifications for Valve clearance, Engine timing and Points gap for my 1973 350SE. If any of you can help me with this it would be greatly appreciated. I am waiting for my manual to arrive but already have the valve covers off and I am eager to resume work on the beast.
|
#2
|
|||
|
|||
Dwell angle: 30 degrees (no gap specs, set with meter)
Timing: 5 ATDC with vac (7 BTDC with no vac) Valve clearance: 0.08 mm intake, 0.20mm exhaust. You MUST have the special crow-foot wrench for this, a standard one will probably only spread. Note that these are mm, not inches! Clearance adjustment is a pure pain. Due to the design of the cam followers, you MUST rotate the engine after adjustements and re-check to insure that you didn't just bind the follower on the ball pin. Good luck! Peter
__________________
1972 220D ?? miles 1988 300E 200,012 1987 300D Turbo killed 9/25/07, 275,000 miles 1985 Volvo 740 GLE Turobodiesel 218,000 1972 280 SE 4.5 165, 000 - It runs! |
Bookmarks |
|
|