|
|
|
|
|
#1
09-16-1999, 02:10 PM
|
|||
|
|||
|
I have a 1986 300E. When I bought it, the hose which feeds the filter box was badly mangled. I finally got around to replacing it and I notice that the new hose has a slot in it to put an air temp or flow sensor into. The problem is, I can find no wires or connectors which would plug into this slot. Did the 1986 300E have one of these sensors? I suppose it's possible that I was sold an intake hose which was meant for a later model with the sensor.
Thanks, Joe Slemp |
|
#2
09-16-1999, 04:30 PM
|
|||
|
|||
|
1986 300E don't have air intake temp sensor
you should find a plug to cover the hole.... ask dealer to find one for you. ------------------ MB STARS Master Guild Technician,12 years MB tech 5 years independent shop owner |
|
#3
09-16-1999, 09:43 PM
|
|||
|
|||
|
If you don't have the plug, don't worry. The hole is down stream of the air filter and won't hurt anything.
------------------ Benzmac: 1987 16V ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil in the air intake? Bad turbo seals? | Hatterasguy | Diesel Discussion | 8 | 10-18-2004 09:27 PM |
| Cold air intake question. | mike690003 | Mercedes-Benz Performance Paddock | 50 | 12-22-2003 09:15 AM |
| C280 EGR Tube Clean Out -Through the Air Intake | sgerus | Tech Help | 9 | 05-23-2003 12:59 PM |
| Blowby and intake air | rcmktg | Tech Help | 1 | 12-16-2002 04:11 PM |
| 124 300D fender vent air intake | Grdenko | Diesel Discussion | 6 | 10-22-2002 04:04 PM |
Linear Mode
