What torque setting to use for oil pan
Does anyone know what torque setting to use on hex bolts that hold the oil pan for a ’95 E420?
|
oil sump to block
m6 9nm m8 21nm m10 40 nm this is for the main pan, as in the alloy one, not the steel sub pan. Joe |
I am installing the lower oil pan
The pan that has the oil drain plug. Will torque numbers you listed be any different?
One other question while we are on this subject, I was told by the local dealer parts man that it would be wise to use silicon on the gasket for better sealing. Any advise on that? Like what type/brand of silicon? Do I apply thin coat to both sides of the gasket or just the pan side? Thanks |
All times are GMT -4. The time now is 03:55 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website