|
|
|
|
|
#1
01-16-2003, 09:02 PM
|
||||
|
||||
no heat to floor
My 1983 300d does not put any heat down to the floor. It does not seem to matter what position the selector is in the heat comes out the side vents and the defroster. If Imanually reach in back of the heater and open the door heat then goes to the floor!Any ideas?
|
|
#3
01-16-2003, 10:57 PM
|
||||
|
||||
|
Sounds like a vacuum problem to me.
Do you get any vacuum to the diaphragm/actuator that is supposed to open that flap? Kent Bergsma at **************.com has a great vacuum troubleshooting manual for DIY'ers. It explains in laymans terms how everything works and steps you thru how to troubleshoot the problem. The manual is only $20 and I feel is well worth the investment when you own a 300D. Good luck,
__________________
Frank 84 500SEL EURO 101K ( JUST LIKE MY 1ST WIFE. GLAD TO GET RID OF HER! ) 85 300D 310K (sold)  90 350SDL 184K sold 83 300D 118K (sold) 88 300E 153k (sold) 93 400E 105K (sold)
|
|
#4
01-16-2003, 11:29 PM
|
||||
|
||||
|
Check out my post here:
floor vents not functioning/opening, HVAC 86' 300E W124 Good Luck - Don't give up! Jerry
__________________
05 E55 03 E500
|
 |
| Bookmarks |
|
|
Linear Mode
