Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 01-30-2003, 07:24 PM
Registered User
 
Join Date: Mar 2002
Location: Great White North!!!!
Posts: 400
car has been dormant for some time.....

and i like to start it but before i do that i think it would be wise to get the oil pressure up.how can i 'prime' the engine before cranking?

__________________
'95 s500 (bought for wife but can't bear to share!!!) 125kms
'92 legend 180kms
'88 tbirdturbo(fantastic car-only regular maint.)120kms
'87 mustang gt(gone)
'86 tbirdturbo(gone)
'85 mustang gt(gone-but not forgotten)
Reply With Quote
  #2  
Old 01-30-2003, 09:32 PM
I told you so!
 
Join Date: Jun 2002
Location: Motor City, MI
Posts: 2,853
How long has the car been sitting?
__________________
95 E320 Cabriolet, 159K
Reply With Quote
  #3  
Old 01-30-2003, 09:45 PM
Registered User
 
Join Date: Mar 2002
Location: Great White North!!!!
Posts: 400
long enough that i'd want to prime it first.if you can't help.......
__________________
'95 s500 (bought for wife but can't bear to share!!!) 125kms
'92 legend 180kms
'88 tbirdturbo(fantastic car-only regular maint.)120kms
'87 mustang gt(gone)
'86 tbirdturbo(gone)
'85 mustang gt(gone-but not forgotten)
Reply With Quote
  #4  
Old 01-30-2003, 09:56 PM
Super Moderator
 
Join Date: Apr 2000
Location: Falls Church, VA
Posts: 5,318
Charge the battery and remove the spark plugs. Crank it for no more than 15 seconds at a stretch and see if the oil pressure comes up.
__________________
Chuck Taylor
Falls Church VA
'66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe
Reply With Quote
  #5  
Old 01-30-2003, 10:00 PM
Registered User
 
Join Date: Feb 2002
Location: Orlando, FL
Posts: 788
Same thing here, my car has been sitting for a long time too. When I get ready to start it again, I am putting in fresh oil. Then I am going to unplug the coil and let it crank for a little bit getting the oil circulating in the engineand get the pressure up. Because if there is any engine damage to be done, I'm sure it is much less at the minimal RPM of the starter as opposed to a cold idle RPM. Only makes sense. Then after that, I am going to plug the coil back in and fire 'er up. Then...I'll let it warm up and then'll I'll "blow out the cobwebs"!

Now I am not saying that to do this, but that's what I was thinking.
__________________
'86 420SE Euro
904 Midnight Blue, Gray Velour
Dad bought it new, now I own it.

"A Mercedes-Benz is like a fine wine, it only gets better with age."
Reply With Quote
  #6  
Old 01-30-2003, 10:01 PM
Registered User
 
Join Date: Feb 2002
Location: Orlando, FL
Posts: 788
Alright...looks like I got beat to the punch!
__________________
'86 420SE Euro
904 Midnight Blue, Gray Velour
Dad bought it new, now I own it.

"A Mercedes-Benz is like a fine wine, it only gets better with age."
Reply With Quote
  #7  
Old 01-31-2003, 01:17 AM
haasman's Avatar
Registered User
 
Join Date: Jun 2001
Location: San Francisco, CA
Posts: 3,097
This is the way I was taught ....

If you can, remove the spark plugs and pull the coil wire. Compression puts a load on the dry cylinder walls.

Run the starter for no more than about 15 sec at a time. Once you see oil pressure ... do it again. The put the plugs in, (no coil) do it again and listen for any bad noises.

If the oil pressure is good, connect the coil and see what you get.

Haasman
__________________
'03 E320 Wagon-Sold
'95 E320 Wagon-Went to Ex
'93 190E 2.6-Wrecked
'91 300E-Went to Ex
'65 911 Coupe (#302580)
Reply With Quote
  #8  
Old 01-31-2003, 07:30 AM
LarryBible
Guest
 
Posts: n/a
What is a long time? What is wrong with specifics?

Good luck,
Reply With Quote
  #9  
Old 01-31-2003, 08:43 AM
I told you so!
 
Join Date: Jun 2002
Location: Motor City, MI
Posts: 2,853
One of my cars, the 71 Cutlass, sits idle for long periods (months). I don't fuss much with it, just start it up normally when I get around to it.

Last year I rebuilt the engine because of serious oil pan leakage. Upon inspection, I found the bearings never suffered from these startups after sitting idle. They were barely worn through the original tin coating.
__________________
95 E320 Cabriolet, 159K
Reply With Quote
  #10  
Old 01-31-2003, 09:09 AM
Registered User
 
Join Date: Feb 2002
Location: Orlando, FL
Posts: 788
My poor Benz will have been sitting for close to 2 years when I finally start 'er again. I've started it a few times after it first went into hibernation and let it warm up, and I drove it a few times up and down the road, but it has been completely shut off now for over a year. There isn't anything I should do on top of this is there?
__________________
'86 420SE Euro
904 Midnight Blue, Gray Velour
Dad bought it new, now I own it.

"A Mercedes-Benz is like a fine wine, it only gets better with age."
Reply With Quote
  #11  
Old 01-31-2003, 09:31 AM
I told you so!
 
Join Date: Jun 2002
Location: Motor City, MI
Posts: 2,853
I think you have a good plan. I hope your car has been in a garage all this time. Being outdoors is tough on a car that's idle. The best thing for an engine that's been sitting for a while is to run it! As long as it starts up and goes, the next items to check out are transmission function, cooling system, and brakes.

Storage is tougher on brakes than on the engine.
__________________
95 E320 Cabriolet, 159K
Reply With Quote
  #12  
Old 01-31-2003, 02:08 PM
csnow's Avatar
Registered User
 
Join Date: May 2002
Location: Mass
Posts: 1,127
I would suggest removing the plugs and squirting some motor oil into the cylinders, perhaps 1/2 oz per cylinder.

If you have a carb, squirt some WD40 down the throat.
It would be best to use fresh fuel as well.

Then, turn the motor with the starter until it builds oil pressure.
Some oil may splash out, but that's ok.

Put the plugs back in, and start it up.

That is probably the bulk of the wear you can easily prevent.


It would be better to take preventive measures at storage.
1) Change the oil. Used oil is acidic, and will slowly (and unevenly)corrode the emmersed moving parts.
2) Add a fuel stabilizer, or drain the fuel.
3) Fog the motor with a fogging oil
-or
At least put 1/2 oz of motor oil in each cylinder, and turn motor with starter for 5 seconds.

Motors hate to sit. Exhaust systems, brakes, various bearings and batteries hate to sit too. Tires can 'flat spot'.
For maximum longevity, drive a car once per week until it reaches operating temp if possible.
__________________
1986 300E 5-Speed 240k mi.
Reply With Quote
  #13  
Old 01-31-2003, 02:23 PM
Registered User
 
Join Date: Sep 1999
Location: Miami, FL
Posts: 645
Marvel Mystery Oil to the Rescue!

When I was a lad, we resurrected and unbent a wrecked MG and the next year, a wrecked Jag. Upon the advice of Charlie O'Dell, Master Mechanic at the Hudson dealer, we squirted Marvel Mystery Oil in each cylinder, after sticking the fuel line in a bucket of fresh "Ethyl" gasoline.

The MG started right up, but the Jag needed a squirt of ether in the carb.

I do not know what is mysterious or marvelous about this stuff, but it is still in the stores and comes in a red and black can.
The Stdebaker mechanic said we could also use Bardahl or even Wynn's Friction-Proofer.
__________________
Semibodacious Transmogrifications a Specialty

1990 300D 2.5 Turbo sedan 171K (Rudolf)
1985 300D Turbo TD Wagon 219K (Remuda)

"Time flies like and arrow, yet fruit flies like a banana"
---Marx (Groucho)
Reply With Quote
  #14  
Old 01-31-2003, 03:02 PM
csnow's Avatar
Registered User
 
Join Date: May 2002
Location: Mass
Posts: 1,127
Re: Marvel Mystery Oil to the Rescue!

Quote:
Originally posted by Richard Eldridge

I do not know what is mysterious or marvelous about this stuff, but it is still in the stores and comes in a red and black can.
The Stdebaker mechanic said we could also use Bardahl or even Wynn's Friction-Proofer.
MMO is just a thin mineral oil with some solvents and detergents added.
Wynn's is reportedly 83% kerosene.

Not so magical, but the results would likely be about the same, and I suppose we are all a bit too cynical these days...

Sure do miss my old MG on those warm summer nights...
Those memories are magical.
__________________
1986 300E 5-Speed 240k mi.
Reply With Quote
  #15  
Old 01-31-2003, 04:53 PM
Registered User
 
Join Date: Sep 1999
Location: Miami, FL
Posts: 645
Marvel Mystery Oil

Apparently this stuff is a detergent and is used for aircraft piston engines.

http://mmd.foxtail.com/Archives/Digests/199808/1998.08.18.20.html

If Bardahl is 83% kerosene, the 17% would be the wonder-working ingredients. After all, beer is 95% water. Moet Champagne is 88% water.

The MG we restored was a 1948 TC. Some of the frame was wood, as I recall, but luckily not the broken part. We worked on it for two months and had it painted British Racing Green. We sold it for $1900. The farmer who had imported it with his wife sold it to us for $150. Gee, I wish I had it today. I saw a TD at the Autoi Show, on sale for a mere $40K.

The electrical parts were cursed by John Lucas, aka the "Prince of Darkness"

I am afraid we replaced the light switch with one from an old Nash Airflyte. A great improvement, considering as how the lights no longer tended to extinguish themselves most uncooperatively while driving down twisty Missouri Highway 10 at 60 mph (which felt like 90 mph in Buick mph's).

__________________
Semibodacious Transmogrifications a Specialty

1990 300D 2.5 Turbo sedan 171K (Rudolf)
1985 300D Turbo TD Wagon 219K (Remuda)

"Time flies like and arrow, yet fruit flies like a banana"
---Marx (Groucho)
Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 05:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page