|
|
|
#1
|
|||
|
|||
How tough is it to swap out the trans modulator in a 116?
I have a 450SEL that shifts hard between 1st and 2nd.
I'm assuming it's either the modulator, or the vacuum going to the modulator. Because the modulator probably has never been replaced, I was thinking of just swapping in a new one. How hard is this to do? I can't find any info on Mercedes trannys. Thanks |
#2
|
|||
|
|||
I would try adjusting it first. Unless fluid comes out when you remove the hollow bolt.
The original modulators had a steel line to them with a banjo fitting and hollow bolt. Remove the hollow bolt and use an allen wrench down the middle to adjust. Try a turn counterclockwise.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
Bookmarks |
|
|