Fuel pump and Coil terminal w126 560SEL
 

I have found what appears to be the electrical distribution block, but it looks nothing like the one in the service manual.

here is what I have:

the block, seperated into three portions. Connected to the top terminal section from the left side is a blue wire which goes to the block and seperates into a blue wire and green/red wire which come out onto the right side. These wires are joined at the block with a Phillips head screw.

Next section down, from the left I have two red cables joined to the block with a bolt and comes out the opposite side to a single red cable. the third section is joined phsically by a metal plate, and has a red cable coming off of it on the right side.

Below the block, i have connected to the fire wall a black cable that goes into a black 'bullet' appox. 2" by 3/4" tapered 1/2" at ingress and egress points. The egress point has a single black cable coming out.

Below this 'bullet' I have what I believe is probably the #16 connector. It has two wires going in and out of it. when you pull the cable connector apart it appears that the connector is silver plated copper. I cannot determine the color of the wires going in other than that one is light and the other is dark.

Let me know how off base I am.

Respects,

Andy:confused:

Picture to go along with plea for help...
 

Please look at this photo and let me know if anyone can identify C as the fuel and coil relay plug. I've searched the archives, found nothing and the picture in my book does not look like this. http://thecatpost.com/images/aaa.jpg

Anyone recognize the picture???
 

Thanks!

I believe that's the positive battery cable connection to the alternator and the fuse block for connection A, i dunno about the rest, but C appears to be for the coolant surge tank or oil level sensor. The coil terminal is by the ABS module, next to the EZL module on the fender, and the fuel pump relay is by the brake booster, it says Kickd. on it.