|
|
|
#1
|
|||
|
|||
Water pump 86 300E Anything special?
Folks, the fun just keeps increasing....I noticed a pool of coolant under my car after doing an oil change. I suspected the water pump and found about 3/8ths of an inch of free play on the pully and evidence of coolant being spun off.. I have not changed one like this before, anything special about it? Seals O rings etc? Also, is there anything that normally has to come off to replace the pump or gain access, that could be replaced/ upgraded? Thanks Scott
|
#2
|
|||
|
|||
Read this thread:
300E water pump replacement using snap on tool ? DrBrandini successfully did the job himself very recently, so you may try e-mailing him directly if you have anymore questions.
__________________
Paul S. 2001 E430, Bourdeaux Red, Oyster interior. 79,200 miles. 1973 280SE 4.5, 170,000 miles. 568 Signal Red, Black MB Tex. "The Red Baron". |
#3
|
|||
|
|||
#4
|
|||
|
|||
China,
Little tip 4 U. U will C a very short water hose about 1.5" i.d. between the pump and the engine , this is visible looking at the top front and right of the engine. Replace this at the same time with new stainless hose clips , because if it fails any time in the future the pump will have to come out again which is not funny |
Bookmarks |
|
|