300E Engine MOunts
 

How difficult is it to change the engine mounts in a 91 300E six cylinder?? And what is the proceedure????


Thanks
Talons40

Since nobody answered yet...
 

the passenger's side is easy. The driver's side is hard to reach but, doable.
Do a seach! It has been discussed before...:cool:

basic procedure:

1 - jack up car
2 - place car on jack stands
3 - loosen - DO NOT REMOVE - top bolt on mount (17mm?)
4 - loosen - DO NOT REMOVE - bottom bolt on mount through access hole in x-member (allen key)
5 - support engine with floor jack and wooden block
6 - remove top bolt on one side
7 - remove bottom bolt from same side
8 - jack up engine until clear of top of mount
9 - re&re mount - ENSURE TAB ON TOP OF MOUNT LINES UP WITH SLOT IN ENGINE SUPPORT ARM
10 - thread top & bottom bolts into mount - DO NOT TIGHTEN
11 - lower engine to hold mount in position
12 - repeat steps 6-11 for other side
13 - tighten bolts according to torque specs.