Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 04-29-2003, 02:17 PM
sixto's Avatar
smoke gets in your eyes
 
Join Date: Jun 2000
Location: SF Bay Area
Posts: 19,744
126 sagging or listing?

If you have a 126 that sits low in the rear or has one side lower than the other in the rear, try this.

Check the gap between the spider plate and the subframe mount just ahead and inboard of the rear jack points. The gap should be even all the way around. I just fit new mounts and the gap is almost 1cm (I can fit a finger through most of the fingernail). It was less than 5cm with the old mounts (I could fit a finger up to a third of the fingernail). I expect some settling of the new mounts so 1cm might be more than I should expect from used mounts.

My 300SE leans to the left and the gap on that side varies between 3cm and none. Hmm...

User Thomaspin has instructions for replacing subframe mounts. There is a link in his sig line on all his posts.

Sixto
91 300SE
87 300SDL
83 300SD
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 07:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page