|
|
|
#1
|
|||
|
|||
When it rains, it pours...
Is this a do it yourselfer? |
#2
|
|||
|
|||
bradfordro,
What model car and can you describe the link bar more specifically? Larry |
#3
|
|||
|
|||
That would help, huh?
It's an 89 190E 2.6 I did some work on it this morning, and a I friends show me the problems. The left wheel was a little lose, and he found that the bushings in the link bar were bad. Also he showed me that the struts were going bad because the "clinked" when i shook the wheels? Thanks |
#4
|
|||
|
|||
This is the front end I presume.The talk of link bushings sounds more like rear end suspension.
The noise you describe sounds like loose wheels bearings. I can't imagine the strut making any noises under hand loading unless the piston has totally come apart (this would be extremely apparant from both the negative camber it would cause and the horrible racket it would cause on the road. This strut holds onto one quarter of a 3000 lb automobile at high speeds and severe dynamic loads. If you can affect it at all with your hands can you imagime what it would be like on the road. If you can feel play look for what is moving the first line of control is the wheel bearing adjustment, next the lower ball joint (can't be checked by hand either - needs to be supported by lower control arm and the the wheel can be lifted with a lever to see the play). The easiest play to be felt by hand (after the wheel bearing) is the steering linkage (they can get very loose but the only noise they make is if they are rusted tight - and squeek). The idler arm bushing also can be felt by hand from the passengers side. All the linkages should actually be check on a wheel lift so they are in the driving attitude. When hanging from frame lifts (or on jacks stands on the body) the tierods can be under tention or in an unworn angle which can hide the play). Other than stabilizer bar links there are no links with or without bushings in the front suspension that play can be felt by hand. The lower control arm bushings almost never are a factor on 124 front ends. The rear end links are a different story. Many can be tested by hand with a little aid of a large screwdriver/pry bar. ------------------ Steve Brotherton Owner 24 bay BSC Bosch Master, ASE master L1 26 years MB technician |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Front sway bar on a 1984 300SD? HELP!!! | 1984300SD | Diesel Discussion | 1 | 06-24-2005 12:40 AM |
Front sway bar replacement | CHAPP | Diesel Discussion | 8 | 02-26-2004 09:54 AM |
Sway Bar Link Replacement-Help | NC240D76 | Diesel Discussion | 2 | 03-02-2003 10:33 PM |
W210 Front Sway Bar Link: Removal | Dalcorn | Tech Help | 1 | 09-24-2002 09:19 AM |
E320 (124) front sway bar fiasco!!! | fhmajid | Mercedes-Benz Performance Paddock | 1 | 08-07-2002 06:26 PM |