|
|
|
|
|
#1
04-08-2000, 10:55 PM
|
|||
|
|||
|
Have disconnected electrical harness from tumbler. There is a bolt (10mm head) through what appears to be a pinch type arrangement on top of the steering column apparently holding the tumbler in. When loosened, the lock will swivel, but will not slide out.
|
|
#2
04-09-2000, 09:41 PM
|
|||
|
|||
|
Look carefully around to the front or bottom of the sleeve under where the clamp was. There is a little pin that you need to depress before you can slide the lock assy out of the steering column. You will have to turn the key to the 1st or 2nd position to do this.
Good luck.... ------------------
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mercedes 380 SLC Ignition Switch | Barry Owen | Tech Help | 2 | 01-25-2004 04:24 AM |
| Instrument Cluster Removal & Seat Switch Plate | meh1998 | Diesel Discussion | 2 | 01-10-2004 07:27 PM |
| Ignition switch doesn't turn off | DonCombest | Mercedes-Benz SL Discussion Forum | 1 | 10-12-2002 09:42 PM |
| 86 190E 2.3 Ignition Switch Probs? | ChinaClipper | Tech Help | 1 | 06-26-2002 07:46 PM |
| 84 380SL Ignition switch removal | Steve Gray | Tech Help | 2 | 11-28-1999 08:24 PM |
Linear Mode
