|
|
|
|
|
#1
08-05-2003, 08:40 PM
|
|||
|
|||
License Plate Fasteners
Does anyone know the size of screws that are used for the license plate? I imagine it would be a metric screw.
|
|
#3
08-05-2003, 11:24 PM
|
||||
|
||||
|
BTW, get a rubber washer for each of your screws. Helps prevent rust betweent the screw head and the plate.
Jeff Pierce
__________________
Jeff Pierce Current Vehicles: '92 Mercedes 190E/2.3 (247K miles/my daily driver) '93 Volvo 940 Turbo Wagon (263K miles/a family truckster with spunk) '99 Kawasaki Concours Gravely 8120 Previous Vehicles: '85 Jeep CJ-7 w/ Fisher plow (226K miles)'93 Volvo 940 Turbo Wagon '53 Willys-Overland Pickup '85 Honda 750F Interceptor '93 Nissan Quest '89 Toyota Camry Wagon '89 Dodge Raider '81 Honda CB 750F Super Sport '88 Toyota Celica '95 Toyota Tacoma '74 Honda CB 550F
|
|
#4
08-06-2003, 01:09 PM
|
|||
|
|||
|
Actually, I think it was a #6 (not 6mm). I recall that it wasn't metric, but was available as a stainless pan head at my hardware store. If you don't have any fasteners, go to your local hardware store and ask, I'm sure they'll let you go to the lot to figure it out with their fasteners.
|
 |
| Bookmarks |
|
|
Linear Mode
