PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   DTC question (http://www.peachparts.com/shopforum/tech-help/73561-dtc-question.html)

Potomac Pat 08-27-2003 08:58 AM

DTC question
 
On a W124.032 (95 E320) I have the check engine light on & using the diagnostic box I have a #2 & a #5.

Any ideas guys?

I haven't become good enough with WIS yet to be able to identify what these mean.

Thanks ! ! !

pfphipps 08-27-2003 09:22 AM

I think this is the right list for your car:

91 & later 300 series (2.8L and 3.2L)
1 No faults.
2 Oxygen sensor inoperative.
3 Lambda control inoperative.
4 Air injection inoperative.
5 EGR inoperative.
6 Idle speed control inoperative.
7 Ignition system failure.
8 Coolant temp sensor-open or short circuit.
9 Intake air temp sensor-open or short circuit.
10 Voltage at Air Mass sensor too high or low.
11 TN (RPM) signal defective.
12 Oxygen sensor heater open or short circuit.
13 Cam position sensor signal from-EZL/AKR ign. control unit defective.
14 Intake manifold pressure at start too low.
15 Full throttle Info defective.
16 Idle speed info defective.
17 CAN Data exchange-Malfunction between control units.
18 Adjustable camshaft timing solenoid-open or short circuit.
19 Fuel injectors-open or short circuit or Emission control system adaptation at limit.
20 Speed signal missing.
21 Purge switchover valve-open or shorted.
22 cam position sensor signal defective.
23 Intake manifold pressure w/ engine running too low.
24 Starter ring gear segments defective.
25 Knock sensors.
26 Upshift delay switch over valve-open or shorted.
27 Coolant temp sensor deviation between sensor ciruits 1 & 2.
28 Coolant temp Sensor.

Potomac Pat 08-27-2003 09:25 AM

Awesome !!

Thanks a million

stevebfl 08-27-2003 09:36 AM

Well it just might not be in WIS. It isn't where its supposed to be and that is Vol 3 of the Engines DM (diagnostic manual). That volume doesn't come up on my WIS.

I do have a paper version and it says O2 sensor for code #2 and EGR for code #5. The next step in diagnosing #2 is to consult the HFM module.

Potomac Pat 08-27-2003 09:42 AM

Thanks Steve

I just got done looking @ the LMVIND code list for the M104 HFM-SFI and it is identical to what was posted. Thanks again guys !


All times are GMT -4. The time now is 11:04 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website